Sanyo PLUS T35 - FM Alignment (Continued); Tuning Meter Center 0 Alignment (Second); IF Gain and VCO Alignment; Separation and Muting Level Alignment

| inPut | OUT Put
Adjusting Pasition of é
stp | Agi | phate esieee Tuning Dial Sra Sailors
palit IF BAND SW
to Wide
TP-12(H ©),{98.0MHz
Separation TP-13(H ®) | (1kHz ae
(Wide) & TP-11(E) | 75kHz * position | R329
or OUT modulation}
PUT
Terminal
Connect IF BAND SW
VTVM to —Narrow
TP-12(H ©),| 98.0MHz
(Narrow) Mey sla *»position | R327
or OUT modulation)
Connect PUT
FM-SG to i
ANT. Terminal
Terminal or | Connect FM-SG=40dB
TP-2(H)
&
|
VTVM
to
Muting
SW
TP-1(E) TP-12(HO), 98.0MHz —Level 2
Muting TP-13(H ®) | 1kHz
(Level 2) & TP-11({E) | 75kHz
or OUT modulation)
PUT
*position | R221.
Terminal
Seat FM-SG=28dB
V to Muting SW
TP-12(H © ),| 98.0MHz Level 1
(Level 1) ee ie «position | R225
or OUT modulation)
PUT
Terminal
98.0MHz
1kHz
75kHz
modulation)
*position
Connect
VTVM to
TP-12
(H ©).
TP-13
(H ®) &
TP-11(E)
or OUT
PUT
Terminal
REC Level
lation)
Note:
FM-SG=65dB
Match IF with the resonance point of the ceramic filter.
REC Level SW
~ON
After 1F V-curve and S-curve adjustments, short-circuit C220 by soldering to form the original circuit.
Turn R209 clockwise to set it in a position to decrease output. Confirm wide/narrow level by lighting sensitivity of a signal indicator.
Adjust in order of Step Nos. given.
Use an IHF dummy of 3002 balanced resistor for FM connecting antenna.
VTVM refer to a vacuum tube voltmeter; DVT VM, digital vacuum tube voltmeter.
Perform a high-precision adjustment for cover adjustment.
Add to AC 115/220V 50Hz.
Use a screwdriver with plastic grip for al! adjustment.
Selector switch to “MW” (“AM”).
Connect Sweep generator, FM-SG, VTVM, DVTVM and Oscilloscope, Countor.
POOBNAARWN>
= a