Sanyo PLV-Z60 - Connecting to Video Equipment (Video, S-Video); Connecting to Video Equipment (Component)

16
Installation
SERVICEPOR
HDMI 1
COMPUTER
COMPONENT 1
COMPONENT 2
S-VIDEO
HDMI 2
VIDEO
Pb/CbYPr/Cr
Video Equipment
S-video
Cable
S-VIDEO
Output
S-VIDEOVIDEO
Composite
Video Output
Video Cable
(RCA x 1)
Video, S-video
Use a video cable or a S-video cable (commercially available).
Unplug the power cords of both the projector and external equipment from
the AC outlet before connecting the cables.
SERVICEPORT
HDMI 1
COMPUTER
COMPONENT 1
COMPONENT 2
S-VIDEO
HDMI 2
VIDEO
Pb/CbYPr/Cr
Video Equipment
Component Video Output
(Y, Pb/Cb, Pr/Cr)
COMPONENT
Component
Use a component cable (optional).
Connecting to Video Equipment (Component)
Component
Cable
(RCA x 3)
✔Notes:
• To order the optional cables, see page 55.
•When connecting HDTV equipment to the projector’s COMPONENT 1/2 terminals,
horizontal line noise may be noted only occasionally. Then adjust the value of Fine sync.
The factory default value of Fine sync is “10.” The setting can be adjusted from 0 to
+31 (see page 33).
This projector can be connected up to six equipment at one time. See the figures below for the connections.
Connecting to Video Equipment (Video, S-Video)