Making a Ready Link Call by Entering a Number
To place a Ready Link call by entering a number:
1. From standby mode, enter the Ready Link number you want to
dial.
2. Press to place the Ready Link call. (Continue holding
to take the floor and speak.)
䡲
The contact’s name appears on the display if there is a
matched number in your Ready Link List.
3. Continue with the Ready Link call, pressing and holding to
speak and releasing it to allow others to reply.
4. When the call is finished, press .
– or –
1. Press R-Link (left softkey) or press .
2. Press Go to (left softkey), highlight Enter R-Link# and press .
3. Enter the Ready Link number you want to dial.
4. Follow steps 2-4 above.
Note:Ready Link numbers must contain 10 digits (area code + phone number) or
11 digits (1 + area code + phone number). Your Ready Link number is the same as
your wireless phone number.
Section 2J: Using Ready Link 129
To Next Page
Loading...
