Sanyo SCP-3200 - Using Voice-Activated Dialing

132 Section 2H: Using Your Phone’s Voice Services
Using Voice-Activated Dialing
In addition to SprintVoice Command (see page 239), you can
use a voice dial tag to automatically dial a phone number in
your Contacts. (A voice dial tag is a command you record and
use to place calls without using the keypad.) Your phone can
store up to 30 voice dial tags.
Making a Call Using Voice-Activated Dialing
With the phone open:
1. Press and hold .
2. Follow the system prompts and recite the entry’s Voice
Dial tag into your phone’s microphone.
With the phone closed:
1. Press and hold .
2. Follow the system prompts and recite the entry’s Voice
Dial tag into your phone’s microphone.
Note:
To use the Voice Dial function, you must have a stored entry
for Voice Dial.(See “Programming Voice Dial Tags” on
page 133.)
Note:
Please set the Voice Prompt feature (see page 53) to on
before using the Voice-Activated Dialing so that you can
hear the voice instruction from the phone. The default
setting is off.