Sanyo SCP-3200 - Page 164

148 Section 2I: Using Sprint Ready Link
Making a Sprint Ready Link Call by Entering a
Number
To place a Sprint Ready Link call by entering a number:
1. From standby mode, enter the Sprint Ready Link number
you want to dial.
2. Press to place the Sprint Ready Link call. Continue
holding to take the floor and speak.
n
The contact’s name is displayed if there is a matched
number in your Sprint Ready Link List.
3. Continue with the Sprint Ready Link call, pressing and
holding to speak and releasing it to allow others to
reply.
4. When the call is finished, press .
– or –
1. Press .
2. Select Go to (left softkey), highlight Enter R-Link# and
press .
3. Enter the Ready Link number you want to dial.
4. Follow steps 2–4 above.
Note:
Sprint Ready Link numbers must contain 10 digits (area code
+ phone number) or 11 digits (1 + area code + phone number).
Your Sprint Ready Link number is the same as your wireless
phone number.