Sanyo SCP-3200 - Page 38

22 Section 2A: Phone Basics
Installing the Battery
To install the Li-Ion battery:
1. Insert the battery into the opening on the back of the
phone and gently press down.
2. Place the battery cover into the position as indicated in the
diagram, and then slide it until you hear it snap into place.
Removing the Battery
To remove your battery:
1. Make sure the power is off so that you don’t lose any
stored numbers or messages. Press the battery release
latch, and then slide the battery cover and remove it.
2. Use your thumbnail to lift and then remove the battery
as indicated in the diagram.
2
3
1
WARNING
Do not handle a damaged or leaking Li-Ion battery as
you can be burned.
3
2
1