Sanyo SCP-6000 - Data;Fax Mode

Changing Your Phone’s Settings 103
Changing Your Phone’s Settings
11 11
Understanding Roaming
11 11 11
Data/Fax Mode
The Sprint PCS Wireless Web
™
Connection Kit (purchased
separately) lets you link your laptop PC to your
Sprint PCS Phone so you can send and receive data and
faxes.
Receiving a Fax
To receive a fax with your phone:
1.
From the Standby mode, press .
2.
Highlight
Wireless Web
, and press .
3.
Highlight
Connection
, and press .
4.
Highlight
Data/Fax (IN)
, and press .
5.
Highlight
Incoming Fax
, and press .
Receiving Data
To receive data with your phone:
1.
From the Standby mode, press .
2.
Highlight
Wireless Web
, and press .
3.
Highlight
Connection
, and press .
4.
Highlight
Data/Fax (IN)
, and press .
5.
Highlight
Incoming Data
, and press .
Returning to Standby Mode
To return to Standby mode at the end of a data or fax
transmission, follow these steps.
To return to Standby mode from Data/Fax mode:
1.
From the Standby mode, press .
2.
Highlight
Wireless Web
, and press .
3.
Highlight
Connection
, and press .
4.
Highlight
Data/Fax (IN)
, and press .
5.
Highlight
Disable
, and press .
Note:
The phone must
be on a digital
network to send or
receive data and
faxes.
Note:
When your phone
is in Data/Fax
mode, you cannot
receive voice
calls.
Note:
The phone always
powers up in Standby
mode, even if it was
powered down in
Data/Fax mode. The
phone also returns to
Standby mode if the data
cable is disconnected.
Tip:
To terminate the data/fax
call, use your Sprint PCS
Dialer software; data/fax
calls typically terminate
automatically. Don’t
press while
sending data; this may
cause your data or fax
application to
temporarily lock up and
could cause loss of data.