Sanyo SCP-6000 - Using Voice Dialing; Programming Voice Dial Tag to Your Phone

Section 14
128 Using the Voice Services of Your Sprint PCS Phone
Using Voice Dialing
You can use a Voice Dial tag to automatically dial a phone
number in your Internal Phone Book. 30 stored entries are
available.
To use a Voice Dial tag to call a phone number:
1.
From the Standby mode, press shortly.
2.
Follow the voice prompts and recite the entry’s
Voice Dial tag into your phone’s microphone.
Programming Voice Dial Tag to Your Phone
To program a voice dial tag:
1.
From the Standby mode, press to display the
main menu.
2.
Highlight
Voice Dial
, and press .
3.
Highlight
Program
, and press .
4.
The phone will prompt you to say the name you want
to program. Wait for the beep and then say the name.
5.
Respond to the prompt by repeating the name after the beep.
6.
Enter or highlight the entry (name) in the phone book
entry list.
7.
Press .
8.
Select the labeled category that includes your desired
phone number. Then display shows “Voice Dial
Recorded”.
OR
1.
Press of the Navigation key to display the phone
book entry list.
2.
Highlight your desired entry, and press .
3.
Highlight your desired label category, and press .
䊳
Email and Web are not applicable.
4.
Highlight
Set Voice Dial
, and press .
5.
Wait for the beep and then say the name.
6.
Respond to the prompt by repeating the name after the
beep.
Note:
Train Voice Dial tags in a
quiet environment and
without the aid of an
accessory (for example,
a headset or hands-free
car kit).