130 Section 2H: Using Your Phone’s Voice Services
Using Voice-Activated Dialing
In addition to Sprint PCS Voice Command (see page 242), you
can use a voice dial tag to automatically dial a phone number
in your Contacts. (A voice dial tag is a command you record
and use to place calls without using the keypad.) Your phone
can store up to 30 voice dial tags.
Note:Please set the Voice Prompt feature (see page 52) to on before using
the Voice-Activated Dialing so that you can hear the voice instruction from
the phone. The default setting is off.
Making a Call Using Voice-Activated Dialing
1. Press and hold , , or .
2. Follow the voice prompts and recite the entry’s voice tag
into your phone’s microphone.
Note:To use the Voice Dial function, you must have stored Voice Tag entries.
(See “Programming Voice Dial Tags”below.)
Tip:You can also make a call using voice-activated dialing with the phone
closed. Press and hold the Side Call key ( ), and follow the voice prompts.
Programming Voice Tags
To program a voice tag:
1. From standby mode, press Contacts (right softkey).
2. Select a contact and press .
3. Select a phone number, and then press Options (right
softkey) > Set Voice Tag > Add.
4. After you are prompted to say the name you wish to
program, wait for the beep and then say the name into
your phone’s microphone.
To Next Page
Loading...
