3
Schedule Timer
How to Copy Group Programs
STEP 1 Press the PROG. COPY GROUP button.
“CP-1” starts blinking in the present time display area and “CP”
(copy) starts blinking in the program
area to indicate the
copy source.
STEP 2 Select a source group program to copy.
Select a copy source group using the GROUP button.
Once having selected the copy source group, press the SET but-
ton to set it.
STEP 4 Enter the selected copy destination group.
When the SET button is pressed, the number of the copy desti-
nation group appears in the program No. area.
NOTE
If a group from numbers 1 to 4 was selected as the copy desti-
nation group, that number appears in the program
area. If a
group from numbers 5 to 8 was selected, that number appears in
the program
area.
STEP 3 Select a copy destination group.
After pressing the SET button, “CP-2” starts blinking in the
present time display area, the copy source group No. set ap-
pears in the program
area, and “PA” (paste) starts blinking in
the program
area to indicate the copy destination.
Select a copy destination group using the GROUP button.
To Next Page
Loading...