Sanyo SPW-C0705DZH8 - How to Use Suspension Hook; Suspension Bolt (M10 or 3;8) (Field Supply)

ATK-RZP160BGWB
Part
number
1
Gas tube: ø15.88
2
Liquid tube: ø9.52
3
Suspension hook
4
Liquid tube: ø9.52
5
Suction tube: ø15.88
6
Discharge tube: ø12.7
7
Earth (M5 with washer)
8
Service panel
9
• Specifications
ATK-RZP160BGWB
Compatibility
5.6 Total capacity of indoor units (kW) 16.0
Power source
Single-phase 200V 50/60Hz (supplied by indoor units)
Power input
Net weight
Accessories
Unit: mm
• Be sure to secure the valve body by using its structure with
the suspension bolt, etc.
• Install the valve body within a distance of 30 m from the
indoor unit.
Some refrigerant noise will be produced. Therefore in
hospitals, libraries, hotel guest rooms, and other quiet
locations, it is recommended that the solenoid valve kit be
installed on the ceiling reverse side of a hallway or another
location separated from the room.
• When installing the valve body, install with the top surface
facing up. Secure 200 mm or more of space to the front so
that the front service panel can be removed.
• If the supplied suspension hook will not be used, and other
fastening devices will be attached in the field, use the 4 screw
holes on the top surface. DO NOT use any long screws other
than the supplied screws. Use of other screws may puncture
the internal tubing, resulting in refrigerant leakage.
• Do not block the air holes.
Suspension hook
Washer
How to use suspension hook
Front side
Service space
More than
200 mm
Types and specifications of tubing connections
Power outlet (connected to a 5 m cabtyre cable
with connector)
Unit: mm
25 W
4.7 kg
Washer × 2
Insulating tape
PCB connector × 1
NOTE
Notes on Installation
Suspension bolt (M10 or 3/8") (field supply)
Nut (field supply)
(M10 or 3/8")
M4 screws (12 pcs.)
147
239
166
27 37 38
51 44
7621
150
11
28
17
150
108
240
149
216
7
2
1
3
6
5
4
8
9
Cool with damp cloth or other means when
brazing the joint with a torch. Otherwise, the
solenoid valve will be damaged.
Gas tube
Discharge
tube
Liquid
tube
Suction tube
Liquid tube
2-38
Design of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
4. Installation Instructions
TD831143-00W-3WAY.indb38TD831143-00W-3WAY.indb38 2008/12/0116:15:502008/12/0116:15:50