Sanyo SPW-C0705DZH8 - Emergency Operation

3-11
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
Use [Emergency Operation] in the following situations when there is an urgent need.
When the remote control’s batteries have failed.
When the remote control is broken.
When the remote control is lost.
*1
Figures: RCS-SH80BG.WL and RCS-TRP80BG.WL are of receivers (inside indoor unit), RCS-SS80BG.WL is of the operation
panel (inside indoor unit) and Indoor Unit (K type) is of its front panel.
Start/Stop
Indoor Unit (K type) RCS-TRP80BG.WL
Start/Stop
RCS-SH80BG.WL/RCS-TRP80BG.WL/RCS-XM18BG.WL/ Indoor Unit (K type)
Start: press [Emergency Operation] of the receiver.
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.
Stop: press [Emergency Operation] of the receiver again.
The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
RCS-SH80BG.WL
RCS-XM18BG.WL
Start/Stop
Start/Stop
RCS-BH80BG.WL / RCS-SS80BG.WL
1. Press [Emergency Operation] of the receiver.
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.
2. If you press ,the wind direction automatically oscillates up and down.
Stop: press [Emergency Operation] of the receiver again.
2 1
RCS-SS80BG.WLRCS-BH80BG.WL
1
2
The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
Emergency Operation
1-11.
NOTE
NOTE
TD831143-00_W-3WAY.indb 11 2008/12/05 9:40:35