3-21
Control of 3-WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
2-17. Test Operation
2-18. Setting Address Switches
This is hard on the device, so only use this for the test run.
After turning on the power, the unit will not receive any commands from the remote control for about 1 minute.
This is not an error. (In fact it does receive signals, but they are cancelled.)
(1)
(2)
Fig.3-23
Implementing a Test Run
2. During a test run, all display lamps on the display will light up.
3. During a test run, it is not possible to adjust the temperature.
DIP Switch Bit 1
When more than one display/operation panel and remote control are installed in the same room, setting up addresses allows
them to avoid interfering with each other.
Refer to the Users Manual for information on how to change the addresses of the remote controls.
Address Display
on the Remote
Control
Position of the
Receiver’s
Address Switch
It doesn’t matter
where the Receiver’s
Address Switch is.
1.Turn the #1 DIP switch of the operation panel from OFF to ON (Down Up) and
operate the wireless remote control with its Start/Stop button.
4. After completing a test run, be absolutely sure to turn the #1 DIP switch from
ON to OFF (Up Down) and make sure none of the display lamps are blinking.
Also, replace the PCB cover back as it was and fasten it; while holding the wiring
in the cable clamp, tighten its screw.
NOTE
TD831143-00W-3WAY.indb21TD831143-00W-3WAY.indb21 2008/12/0110:26:252008/12/0110:26:25
To Next Page
Loading...
