Sanyo SPW-CR703GDCH8 - Simplified Remote Controller; How to Use the Simplified Remote Controller

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 62
2. Optional Controller (simplified remote controller)
2-4. Simplified remote controller / RCS-KR1TG
7 How to use the simplified remote controller
1504_T_I
CENTRAL CTRL
CHECK
SET TEMP.
°C
STANDBY
A
SETTING
TEST
TEST
SET TEMP. FAN SPEED
MODE
ON - / OFF -
FLAP
A
SENSOR
D: FAN SPEED
selector button
B: MODE button
E: FLAP button
C: Temperature
setting buttons
F: Temperature
Sensor (Internal)
A: ON/OFF operation button
G: TEST button
A: ON/OFF operation button This button is for turning the air conditioner on and off.
B: MODE button Use this button to select one of the following five operating modes.
(AUTO)
A
: Used to automatically set cooling or heating operation.
Only for single heat pump type
(temperature range: 17 - 27 °C)
(HEAT)
: Used for normal heating operation.
Only for heat pump type
(temperature range: 16 - 26 °C)
(DRY)
: Used for dehumidifying without changing the room temperature.
(temperature range: 18 - 30 °C)
(COOL)
: Used for normal cooling operation.
(temperature range: 18 - 30 °C)
(FAN) : Used to run the fan only, without the heating or cooling operation.
C: Temperature setting buttons : Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.