Sanyo SPW-CR703GDCH8 - Page 132

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 74
2. Optional Controller (AMY adapter)
7 How to install the AMY adapter (SHA-KC3500G)
No. Accompanying parts Q’ty
1 1
2 4
7 Accessories
Fixture
Screws (4 × L12)
For fixture
No. Accompanying parts Q’ty
3
1
4 1
Screws for
Nylon clamper
(3 × L8)
Nylon clamper
150
200
AMY adapter
65
3
260
1835_M_I
CAUTION
¶ Dimension ¶ Electrical specs.
Rated voltage
: 220/230/ 240 V
Frequency
: 50 Hz
Input
: 5 W
Net weight
: 1.5 kg
¶ Do not strand or twist
inter-unit control wire.
AMY control wire and
input-output wire with
power cord, or thread
them through a metallic
pipe because it may
causes faulty operation.
¶ Install AMY adapter apart
from electrical noise
source.
¶ Do not install AMY adapter
where water splashes or
humid place.
¶ Avoid excessive vibration
and shock.
260
200
30
131
60
35
Fixture
Hole for slip-off
prevention screw
1836_M_I
Wall
Hook the AMY adapter to the fixture
Screw for slip-off prevention
1854_M_I
(1) Secure the fixture according to the <Measurement
for installation>.
(2) Hook the adapter to the fixture.
(3)
When the fixture is loose and the AMY adapter
seems to be slipped off, secure the AMY adapter with
a screw removing the upper lid of the AMY adapter.
7 Layout electrical terminals
When connecting or disconnecting AMY adapter, turn off
the power source. Remove two screws fixing upper lid,
then remove the lid.
(1) Connecting the power source.
Apply AC 220 V to 240 V of the power source to
AMY adapter. Connect the power cord <TB1-1>
and <TB1-2> on the small size printed circuit board
in AMY adopter.
Signal input for
turn-off the
all units.
Relay output 1
Relay output 2
Pulse input 1
Pulse input 2
Pulse input 3
AMY control wire
connection terminal
AC power source
input connection
terminal
(AC 220-240)
Grounding
terminal
Large P.C.B. (Main)
Address setting
and other setting
switch
Address setting
switch
Power
switch
OFF
TB1
TB1
1
TB1
1
POWER
ON
OFF
3
FG
TB2
DDR-3500 MAIN-2
SW1
SW2
DDR
3500-POW-1
SW1
DO1 DO2 D1 P1 P2 P3
12
4
Small
P.C.B.
Inter-unit control
wire connecting
terminals
0
1855_M_I