Control of W-ECO MULTI SYSTEM
3
TD831077
III - 7
2. Optional Controller (remote controller)
NOTE 1) When multiple remote controllers are used, the most recent button that is pressed
on any remote controller is effective, except for timer operations and mode setting.
2) When “CENTRAL CONTROL” is displayed on the LCD, any operation (setting) is
made by system controller. When “CENTRAL CONTROL” is flashing on the LCD,
ON/OFF operation is not accepted by system controller (remote control inhibited).
E: FAN SPEED button
A
The air conditioner automatically decides the fan speed.
High fan speed
Medium fan speed
Low fan speed
F:
button Use this button to reset the filter sign (timer).
(Filter) The air conditioner has the timer for filter and informs you the time of
cleaning the filter.
G: TEST RUN / CHECK This button is used only when servicing the air conditioner.
Do not use the TEST / CHK button for normal operation.
H: FLAP button Use this button to set the airflow direction at a specific angle or to make
the airflow direction sweep to up and down automatically (SWEEP).
Airflow direction or
SWEEP
indication is displayed on the remote control-
ler.
Operation mode Number of airflow direction settings
COOL or DRY 3
HEAT or FAN 5
¶ In the cool mode and dry mode, if the flaps are set in a down-
ward position, condensation may form and drip around the vent.
¶ Do not move the flap with your hands.
I: TIMER SET button Use this button to set the timer at which you wish the air conditioner to go
on or off.
:
The air conditioner stops after the length of time set.
: The air conditioner stops after the same set time
every time.
:
The air conditioner starts after the length of time set.
J: Timer setting buttons Press this button to increase the time.
Press this button to decrease the time.
NOTE ¶ When more than one remote controller is being used with the twin-
type, triple-type, etc, a sub remote controller can not be used for
timer operations.
¶ If a power failure occurs, the time counted up to that point will be
memorized. After the power is restored, the timer again starts
counting up to the set time.
K: Unit button Use this button to select the indoor unit in case of group control.
Cannot be used in other case.
L: CLEAR button Use this button to clear the timer setting.
M: SET button Use this button to set the timer setting.
CAUTION
CAUTION
OFF
OFF
ON
To Next Page
Loading...
