Sanyo SPW-CR703GDCH8 - Page 84

Control of W-ECO MULTI SYSTEM
3
TD831077
III - 26
2. Optional Controller (remote controller)
d Set the No. of R. C. which you want to set with , ( ) button.
e Press the SET button.
UNIT No., CODE No. 12,
SETTING
and SET DATA (0002) change from flashing to ON state.
f Select the CODE No. 13 to set the indoor unit No. with the , (SET TEMP) button.
g Set the indoor unit No. which you want to set with the , ( ) button.
Ex. Indoor unit No. will be set 4.
In this example, indoor unit address (UNIT No.) will
be set 2–4.
Ex. No. of R. C. will be set 2.
h Press the SET button.
UNIT No., CODE No. 13,
SETTING
and SET DATA (0004) change from flashing to ON state.
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
842_8132
SET CL
MODE
FAN SPEED
ON
OFF
•
•
SET TEMP.
UNIT
FLAP
AIR FLOW
R.C. No.
SET
UNIT No.
No.CODE
TIMER SET
DATA
SETTING
TEST / CHK
843_8132