Control of W-ECO MULTI SYSTEM
3
TD831077
III - 64
2. Optional Controller (simplified remote controller)
Display (Remote controller)
Description
A : This is displayed to indicate that the system controller is being used for control.
When
CENTRAL CTRL
is flashing on the display, the operation is not accepted by the system controller.
B : When the unit is in the heating standby mode, the STANDBY indicator appears.
C : This displays the temperature setting.
D : This displays alarm messages when an error occurs.
E : This is displayed when using the temperature sensor in the remote control unit.
F : This is displayed only if an abnormality occurs within a unit.
G : The currently selected FAN SPEED is displayed.
H : When the TEST button is pressed, the TEST indicator appears.
I : The currently selected operation mode is displayed.
1505_T_I
CENTRAL CTRL
CHECK
SET TEMP.
°C
STANDBY
A
SETTING
TEST
TEST
SET TEMP.
FAN SPEED
MODE
ON - / OFF -
FLAP
A
SENSOR
I
H
G
A
D
B
C
E
F
To Next Page
Loading...
