To Next PageTo Next Page
Need help?Do you have a question about the Sanyo SPW-FTR124EH56 and is the answer not in the manual?
General| Brand | Sanyo |
|---|---|
| Model | SPW-FTR124EH56 |
| Category | Air Conditioner |
| Language | English |
General safety precautions, hazard warnings, and cautions for potential damage.
Guidance on installing units in various environments like rooms, moist areas, high winds, and snow.
Precautions for connecting refrigerant tubing, including ventilation and flame avoidance.
Safety measures for servicing, emphasizing power disconnection and clearance from moving parts.
Explains refrigerant density limits and safety measures for room installation to prevent suffocation.
Details standards for minimum room volume based on ventilation and partition conditions.
Illustrates the relationship between minimum indoor floor space and total refrigerant amount.
Lists tools not supplied and accessories provided with the unit.
Specifies requirements for copper tubing, insulation, and other installation materials.
Defines required space and outlines four possible positions for unit installation.
Details floor, wall, and under-ceiling installation procedures.
Instructions for drilling holes for pipes and the condensate drain.
Steps for attaching brackets and hanging the unit onto them.
Covers condensate drain installation and reassembly of panels and grilles.
Important safety and general precautions for performing electrical wiring.
Specifies wire size, length, and fuse capacity for power supply systems.
Illustrates wiring diagrams for power supply and inter-unit connections.
Describes the 7P terminal board layout for connections.
Guidelines for connecting outdoor units in a network, including prohibited configurations.
Rules for branching inter-unit control wiring, limiting branch points.
Explains the use of shielded wires for inter-unit control wiring and grounding.
Step-by-step guide for connecting stranded wires to terminals using ring connectors.
Detailed steps for flaring copper tubes and defining good flare characteristics.
Cautions before connecting tubes, including lubricant, alignment, and brazing safety.
Specifies torque and techniques for tightening flare nuts, and tube wall thickness requirements.
Specifies insulation requirements, thickness, and how to tape flare nuts.
Lists desirable characteristics for insulation materials used.
Guides on taping refrigerant tubes and electrical wiring together with armoring tape.
Instructions on using sealing putty to seal wall holes after tubing installation.
Steps for mounting the operation controller and connecting its wires.
Lists accessories included for installing the wireless remote control receiver.
Critical safety warnings before cleaning the air conditioner unit.
Instructions for cleaning indoor unit parts and the air filter.
Guidance on installing an optional "Air Clean" filter.
Lists common troubles like unit not running or compressor stopping, with causes and remedies.
Explains reasons for reduced cooling/heating performance and how to address them.
Advises on optimizing energy usage through proper installation and maintenance.
