Sanyo VHR-1110 Series - ADJUSTMENT Sae

2-6. ADJUSTMENTS
2-6-1. REEL BASE HEIGHT (See Fig. 2-6-1.)
If the supply reel base or the take-up reel base is replaced, it
will be necessary to adjust the reel base height.
(1) Attach the cassette stand plate gauge (VHJ-0001) and
slide the gauge in the direction of the arrows.
(2) Confirm that, when the gauge stops, the reel bases are
not in contact with surface A of the plate and are in con-
tact with surface B.
(3) If the reel base is in contact with surface A, remove a
spacer and check again.
Cassette stand
plate
(VHJ-0001)
2-6-2. BACK-TENSION LEVER POSITIONING (See Fig. 2-
(1) Begin the playback mode without inserting a tape
cassette. After loading finishes, disconnect the power cord
from the power outlet.
(2) Attach the back-tension lever position-confirmation
gauge (VHJ-0013).
(3) Check to be sure that the back-tension lever is within
the marking line on the back-tension lever position-
confirmation gauge.
gauge
6-2.)
95
(4) If the reel base is not in contact with surface B, add a
spacer and check again.
(Note)
Adjust the reel base height by adding or removing spacers
(0.13t, 0.2t, 0.25t and 0.5t) as appropriate so that the
height meets the specifications. Use the same method for
both the take-up reel base and the supply ree! base.
(The 0.5t washer is included as the standard washer.)
Cassette stand
plate gauge
—_—»>
Reel base
~<+——— Speacer
(4) If is not, adjust the screw (a) so that it is with in the
line.
(5) Remove the back-tension lever position-confirmation
gauge.
(Note)
Handle the back-tension lever position-confirmation gauge
carefully when attaching and removing it, so as not to
damage the video heads.