Sanyo VHR-1110 Series - Page 27

ne
2 Back-tensiomlever
sauge, Koy eauyimation
gauge
we Ach
WNIT
2-6-3. BACK-TENSION TORQUE
(1) Load the cassette torque meter (VHJ-0016) and set
to the PLAY mode.
(2) Check whether or not the back-tension ee value is
wihin 45 ~ 70g-cm.
(3) If not, the bracket position should be sinjuetad’
(A) Press the EJECT button and eject the cassette
torque meter.
(B) Remove the screw (a) and change the position of
the bracket (b).
(4) Load the cassette torque meter once again and check
the back-tension torque value.
Sams |)
SD IMMI III
(Top View)
Back tension lever
(Torque value
mecreases)
def (2
Reel base
en (a)
Bracket (b) (Torque value
Fig. 2-6-3 decreases)