Sanyo VHR-220 series - Page 2

3502L11(N)
1. CIRCUIT BOARD LOCATIONS
1-1. MAIN
BOARDS
L13L068
PW-1 (PowersuPPlY)board=
CP-1(Video,Servo& Audio)board
\< / rTB-’(Termina’)ba‘deo‘re-amp‘“”n /
TM-
N2A’L.
— RFconverter
TM-2 (Operation)board
J ~~y~::;
(Operationkey & Display)board
Installedspecificequipmentand models
TM-5 (OSA:on screenassist)board:VHR-230G, 230EX, 235E, 25SP, 25PR
TM-8 (VPS)board:VHR-220G, 230G
VD-1 (MESECAMdet.)board:VHR-220PS
Appearanceand specificationsare subjecttochangewithout notice.
Fig. 1-1
1-2. LOCATION FOR TAPE PATH ADJUSTMENT
NOTE: Test point TP182 and TP183 for tape path adjustment is shown in figure below.
For adjustment, refer to the separate volume
“Mechanism Service Technical Information”.
P06L018
Shield
case
\
n
o
‘p”” 07(
*
J
TP183
TP182
SW-P.
ENV.
Fig. 1-2 Video pre-amp unit
:.
–l—