Sanyo VM-D6P - DATE;TIME IMPRINT; SETTING THE DATE;TIME

DATE/TIME IMPRINT
The date/time of the recording can be imprinted in your
recording. See "SETTING THE DATE/TIME” on this page.
DATE IMPRINT
1. Press the DATE/TIME button.
The DATE indication wil! appear in the viewfinder.
TIME IMPRINT
1. Press the DATE/TIME button once again.
The DATE indication changes to TIME indication.
To stop the date/time imprint. press the DATE/TIME
button again.
Important Note :
If “88 : 88" flashes when pressing the DATE/TIME button, that
is because either that date was erased due to exhaustion of
the lithium battery or the date has not yet been set (initial
state). Set the date by following the "Date Setting" procedure
outlined below. (Replace the lithium battery if this is the
source of the problem. See page 7)
SETTING THE DATE/TIME
Example : 14:10 24 December, 1990
1. Press and hold down the DATE/
TIME ADJ button for about one
second.
The date indication will appear in
the viewfinder.
2. Press and hold down the DATE/
TIME button until the day
indication approaches the desired
one.
Release the button, then press it
repeatedly to slowly change the
day indication (e.g. set to "24").
3. Press and release the DATE/TIME
ADJ button, then press the DATE/
TIME button to set the month
indication (e.g. set to “12").
2412.89
4. Press and release the DATE/TIME
ADJ button, then press the DATE/
TIME button to set the year
indication (e.g. set to "90").
24.12.90
DATE/TIME button
DATE/TIME ADJ button
Press and release the DATE/TIME
ADJ button, then press the DATE/
TIME button to set the hour
indication (e.g. set to “14").
Press and release the DATE/TIME
ADJ button, then press the DATE/
TIME button to set the minutes
indication (e.g. set to “10").
14: 10
Press and release the DATE/TIME
ADJ button.
The TIME indication will disappear
from the viewfinder.
Note : :
e The date/time cannot be set during recording or
playback. Set the date/time during the STOP, PAUSE,
FF; or REW mode.