Sanyo VM-D6P - PREPARATIONS; POWER SOURCE

PREPARATIONS
POWER SOURCE
Outdoor Use :
For outdoor recording, use supplied battery pack NP-55.
Attaching the Battery Pack
1. Align the iine on the battery pack with the unit.
2. Gently press the battery pack toward the unit, then slide
it to the right, until it "clicks" into place (arrow 6).
Removing the Battery Pack
1. Press and hold down the battery eject lever (arrow G9).
2. Slide the battery pack to the left (arrow 6).
Indoor Use :
For indoor recording, use supplied AC adaptor VAR-30B or
VAR-30C.
a) Attach (or remove) the power connection cord using the
procedures in steps 1 and 2 above "Attaching the Battery
Pack" (or "Removing the battery pack").
b) Connect the AC adaptor's plug to an AC outlet. The green IMPORTANT
power lamp will light. The wires in this mains lead are coloured in
c) When finished recording or playback, disconnect the AC accordance with the following code:
adaptor's plug from the wall outlet.
The AC adaptor can be used in countries with line voltages Blue: — Neutral
between 100 V AC and 240 V AC. EE Lee
As the colours of the wires in the mains lead
of tnis apparatus may not correspond with
the coloured markings identifying the
terminals in your plug proceed as follows.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured blue or black.
The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured brown or red.
To DC OUT terminal
Power connection cord
Notes : .
@ The battery pack supplied with this unit has not been charged. Charge it before initial use. (See page 5)
eDo not use VAR-30B or VAR-30C AC adaptor to supply power for other than VM-D6P 8mm camcorder.
€ When removing the battery pack or power connection cord, power should be switched OFF.