MULTIBRAND UNIVERSAL REMOTE CONTROL;
IMPORTANT NOTE: If
the batteries in the
remote control are
replaced, the codes for
the
TV
, CATV convert-
er/decoder and DSS
receiver must be reset.
Write your code numbers
below for future
refer-
ence.
TV:
_ _ _ _
CATV:,
_
__
_
DSS:
__
_ _
Place the supplied label
on
the back of the remote
control.
14
Your remote control
is
capable of operating your VCR as well as
limited functions of certain televisions, cable (CATV)
converters/decorders and
DSS (Digital Satellite System)
receivers.
In
addition, this remote control is programmed with the
remote control codes of many popular brands, listed
on
the nex
i\
page.
Follow the instructions below to set the appropriate code for your
TV.
SETTING THE REMOTE CONTROL CODE
1
In
the chart
on
the next page, find the code corresponding to
your brand.
2 While holding down the
TV
or
CATV corresponding to your
device, enter the 2-digit code using the number
(0-9) (see
the next page).
The remote
control
is
now set
to
your device.
TV MODE OPERATION
To
use the remote control with your TV, press TV.
You
can use
POWER, 1 00/ENTER, INPUT, CH/TRACK (A/'f'), VOL
(+I-)
and number (0-9) buttons to control the
TV.
CATV MODE OPERATION
To
use the remote control with your cable (CATV)converter/
decoder or
DSS
(Digital Satellite System) receivers, press
CATV.
You
can use POWER, 100/ENTER, INPUT,
CHITRACK
(A/'f')
and number (0-9) buttons
to
control the CATV convert-
er/decoder or DSS receiver.
iNO'IE&)
• Only remote-controlled products can be operated using this
remote
control. (Refer
to
the instruction manuals for your
TV,
CATV converter/decoder or
DSS
receiver instruction manual
for more details.)
•
There may be some
TV,
CATV converter/decoder or
DSS
receiver models that cannot
be
operated with this remote con-
trol.
If
this
is
the case, use the original remote control supplied
with your equipment.
• Cable companies may charge
an
extra monthly fee to activate
the remote
control feature of a rented CATV
converter/decoder.
If
this
is
the case, this remote control will
not operate the cable converter/decoder unless such arrange-
ments are made with the cable company.