ND
RMAL RECORDING ,
Always use PAUSE for
best results when making
changes during recording.
For example:
To
change
channels during recording,
first press
PAUSE to put
the unit
in
pause mode.
Then select the desired
channel
on
the VCR, and
press
PAUSE again to
resume recording.
PREPARATION
• Turn
on
the power of both the VCR and
TV.
• Be sure the TV is set to the VCR Output Channel (CH 3 or
4)
.
•
If
a direct VIDEO/AUDIO connection
is
made between the
VCR and the TV, set the TV's source selector to VIDEO.
1 Insert the video cassette that the safety tab is
in
place.
2 Select the desired channel by using CH/TRACK
(
~
)
.
•
If
you are recording from another source via audio/video input
jacks (at the Rear or Front panel), select the
LINE1
or LINE2
by pressing INPUT.
3 Set the desired speed (SP or SLP) by pressing SP/SLP.
• This
VCR
is not designed to record
in
LP
mode.
4 Set the MTS mode as desired (See page 18, 37).
5 Press REC once.
Recording
will start. (The REC will appear)
•
If
a cassette with
no
safety tab
is
loaded, the cassette will
be
ejected automatically.
6 Press STOP to stop recording.
•
If
the tape reaches the end before STOP
is
pressed, the VCR
wi
ll
automatically stop, rewind, eject, and
it
will turn itself off.
To
PAUSE the recording
During the RECORDING mode ...
1 Press PAUSE
or
PAUSE/STILL on the front panel to pause
the tape.
The
RECP
will show
on
the VCR indicator panel.
2 When you want to continue recording, press PAUSE or
PAUSE/STILL on the front panel again or press REC.
• After 5 minutes in pause mode, the tape will be stopped
automatically to protect the tape and the video heads.
To
record one TV program while watching another
1
Press
TVNCR
to select the TV mode during recording.
The
VCR indicator disappears.
2 Using the
TV,
select the channel to
be
viewed.
27
To Next Page
Loading...
