CABLE ANTENNA( CATV)
CONNECTIONS
..-----.~
75ohm
Cable
System
CABLE
CONVERTER
c:::J
75 ohm U
):ll:f
)oo(';Jl::f)-.1
Cable
System
~
I'Y.
'XR
C:
IN OUT
~0--@L
><
VHF/UHF
/CATV
TV
set
~~$
75 ohm Coaxial Cable (Supplied)
VCR's Back
Panel
Without Cable Box
If your cable wire is connected to your TV without a converter or descrambler
box,
unscrew
the wire from your TV and attach it to the
ANT.IN connector
on
the VCR. Use the supplied
round coaxial cable to connect between the VCR's VHF/UHF/CATV connector and the
75
ohm antenna input connector on the
TV.
With this connection, you can receive all midband,
super band, and hyperband
channels.
With Cable Box
If a converter is required
in
your cable system, follow the instruction below:
The cable hookup permits both TV and VCR operation.
To view or record CATV channel
1 Set the TV channel to the video output channel as located
on
the back of the VCR (CH3
or CH4).
2 Set the VCR channel selector to the output channel of the Cable Converter box by press-
ing the
CH/TRACK (
.A
lY) or
nu
mber (0-9)
of
your VCR. (Example: CH3)
3 Select the channel to view at the Cable Converter Box.
N
TES
• With this connection, you CANNOT record one program while viewing another.
• Channel memory programming
is
not needed when using the connection.
To Next Page
Loading...
