Method 2:
Under monitoring mode interface, press key, switch to next monitoring parameter item d-xx, press key to
move flicker bit to ones digit of the monitoring code, then adjust key or key until the monitoring code displays
d-05, then operate according to step 2 and step 3 of method 1.
Example 3: check fault monitoring parameter in fault status
Under fault status press key and check D group monitoring parameter ranging from D-00 to D-57.
If the fault wasn’t eliminated during checking the fault parameter, the interface will automatically switch to fault alarm
display 5s later after stopping operation.
The fault code displays ranging from D-48 to D-57 (the current status and latest 3 times).
3.8 Function Code Setting
The function parameter system of this inverter includes function code F0～FF, fault code E group and monitoring code D
group. Each function group is consisted of several function code, which is marked as (function group code + function
code). For example, “F5.08” means eighth function code in the fifth function group.
Function code setting example:
Example 1: change frequency setting of forward jogging form 5Hz to 10Hz (F1.20 modified from 5.00Hz to 10.00Hz)
① Press key to enter programming status, LED displays function code F0.00, flicker bit stays in the ones
digit.
To Next Page
Loading...
