SANYU SY5000 Series - F4 Group: Torque Control Configuration; F4.11-F4.15 Torque Control Configuration

51
F 5.00
V/F curve set
0：linear curve
1：decreasing torque curve 1
（1.3 power）
2：decreasing torque curve 2
（1.5 power）
3：decreasing torque curve 3
（1.7 power）
4：square curve
5 ： user set V/F curve
（determined by F5.01～F5.06）
1
0
×
F 5.01
V/F frequency F1
0.00～F2 (frequency value)
0.01Hz
12.50
×
F 5.02
V/F voltage V1
0.0～V2 (voltage value)
0.1%
25.0%
×
F 5.03
V/F frequency F2
F1～F3 (frequency value)
0.01Hz
25.00
×
F 5.04
V/F voltage V2
V1～V3 (voltage value)
0.1%
50.0%
×
F 5.05
V/F frequency F3
Freq. Value F2～【F2.02】rated
freq. of motor
0.01Hz
37.50
×
F 5.06
V/F voltage V3
Voltage value V2 ～ 100.0 ％ *
【F2.04】rated voltage of motor
0.1%
75.0%
×
F 5.07
Torque boost setting
0.0 ～ 30.0 ％ *rated voltage of
motor【F2.04】
0.1%
Depending
on model
×
F 5.08
Torque boost cutoff
point
0.00～rated freq. of motor
0.01Hz
15.00
×
F 5.09
V/F control slip
frequency
compensation
0.0～200.0％*rated slip
note ： default as 100.0% in
0.1%
0.0%
○