What to do if my Saratoga Spa Empire is not operating?
If your Saratoga Spa Hot Tub isn't operating, first check the power source to ensure it's properly connected and active. If the power source is fine, try resetting the GFCI breaker. If the breaker continues to trip, it is recommended to contact your dealer.
How to fix a Saratoga Spa Empire light that is out?
If the light in your Saratoga Spa Hot Tub is out, it may be due to a burned-out Color Blast™ Light, which requires replacement with a new one. Alternatively, the light may simply not be turned on; press the light key to select your desired style and performance.
What to do if I can't operate the main control panel on my Saratoga Spa Empire Hot Tub?
If you are not able to operate the main control panel of your Saratoga Spa Hot Tub, the panel may have malfunctioned. In this case, it is recommended to contact your dealer.
How to fix poor water flow through jets in my Saratoga Spa Empire Hot Tub?
If you're experiencing weak or no water flow through the jets of your Saratoga Spa Hot Tub, try these steps: * Clean the filters, as dirty filters can restrict water flow. * Ensure the water level is adequate, fill the spa to 2" above filters. * Address potential air lock by priming the pump(s). Loosen the unions on the pump(s) until you hear air escaping, then tighten them.
General| Brand | Saratoga Spa |
|---|---|
| Model | Empire |
| Category | Hot Tub |
| Seating Capacity | 6-7 |
| Heater | 4.0 kW |
| Pump | 2 x 5.0 HP |
| Voltage | 240V |
| Amperage | 50A |
| Insulation | Full Foam |
| Control System | Balboa |
| Shell Material | Acrylic |
| Cabinet Material | Synthetic |
To Next Page