System Menu
46 Operating Instructions Arium
®
Comfort I, Comfort II
8.3.4 ECO-Mode
For economic and ecological operation of the system, we recommend that
you switch the Arium
®
Comfort system to Eco mode when no water is being
dispensed. In the Eco mode, the water in the system is recirculated every
hour for 15 minutes. The purpose of this is to guarantee high water quality
even during longer periods of operation.
The Eco mode can be activated manually and automatically. A dark, empty
display and a yellow backlit Eco/Home key indicate that the Eco mode is
activated.
Manual activation
t In the operating mode, press and hold the Eco/Home key for at least
seconds.
Automatic ECO mode
The Eco mode can be activated automatically after the automatic ECO
time has elapsed. The time starts following the last operating process.
Under Menu Settings Eco mode, set the Eco time.
If you enter a time of “0 hours 00 min”, the automatic ECO mode is
deactivated.
The maximum Eco time is 9 hours 59 minutes.
Exit Eco mode
Exit the Eco mode by pressing the Eco/Home key.
The system switches back to operating mode.
In ECO mode, the tank is filled continuously.
The automatic ECO mode is factory-set to 10 minutes, and | or pre-set to
8.3.5 Flow Rate Sensor
Depending on the environmental conditions (e.g. temperature), minor
deviations in the volume-controlled dispensing may arise. To compensate
for these deviations, you have the option to make minor adjustments using
a correction value. The flow rate can be corrected between +3 (maximum
increase) and -3 (maximum reduction).
This function is located under Menu Settings Flow rate sensor.
r r ECO-Mode
Automatic ECO mode:
0 h 10 min
r r Flow rate sensor
Correction value:
+ 0
To Next Page
Loading...
