Care and Maintenance
70 Operating Instructions Arium
®
Comfort I, Comfort II
t Start the rinsing process.
y The new softener and | or the prefilter softener are rinsed for 10 minutes.
t Connect the “Tank Outlet” tubing to the Arium
®
Bagtank (“IN” tank
connection).
Replacing the softener is complete. Your Arium
®
Comfort system switches
to the operating mode.
9.6 Tank Rinsing
A new bag may give off TOC into the pure water it contains. If you need
water for TOC-critical applications after a bag replacement, Sartorius
recommends rinsing the bag first.
The tank rinsing duration depends on the following parameters:
Arium
®
Type (Comfort I or Comfort II)
Type of Arium
®
Bagtank (20, 50, or 100)
Number of RO modules in the Arium
®
Comfort system
The fill level in the tank before starting tank rinsing
The following table provides reference values for tank rinsing times. The
times apply to an empty tank at the beginning of a tank rinsing procedure.
Given the long rinsing time, it is recommended to rinse the tank overnight.
Bagtank 20 Bagtank 50 Bagtank 100
Arium
®
Comfort I –
2 RO modules
approx. 2.5 h approx. 6.5 h approx. 13.5 h
Arium
®
Comfort I –
1 RO module
approx. 5 h approx. 13 h approx. 26 h
Arium
®
Comfort II –
2 RO modules
approx. 4 h approx. 10.5 h approx. 21 h
Arium
®
Comfort II –
1 RO module
approx. 8 h approx. 20.5 h approx. 41 h
Care r Softener
Start rinsing process
Start
Care r Softener
Rinsing
10 min
Cancel
Care r Softener
Connect “Tank outlet” tubing
to tank
OK
To Next Page
Loading...
