Sartorius BioPAT Xgas - Page 21

Operating Instructions BioPAT
®
Xgas 21
Installation
Connecting to Biostat
®
B-DCU II
t Connect the analog signal outputs of the
BioPAT
®
Xgas to the analog inputs on the
Control Tower of the Biostat
®
B-DCU II as
follows:
t Take the analog Y signal cable.
t Connect the plug of the Y cable labeled
“Xgas” to the right female connector of the
BioPAT
®
Xgas.
t Connect the plug of the Y cable labeled
“Ext. Sig.-A” to the female connector

®
B-DCU II.
t Connect the plug labeled “Ext. Sig.-B” of
the Y cable to the female connector

®
B-DCU II.