Sartorius BioPAT Xgas - Page 22

22 Operating Instructions BioPAT
®
Xgas
Installation
Connecting to Biostat
®
B (Serial No. > 1000)
t Connect the analog signal outputs of the
BioPAT
®
Xgas to the analog inputs on the
control tower of the Biostat
®
B as follows:
t Take the analog signal cable.
t Connect the cable plug labeled “Xgas” to
the right-hand socket of the BioPAT
®
Xgas.
t Connect the cable plug labeled “Ext. Sig.


the Biostat
®
B depending on the DCU
signal configuration for off-gas analysis.