Sartorius BioPAT Xgas - Page 23

Operating Instructions BioPAT
®
Xgas 23
Installation
Connecting to Biostat
®
C Plus
t Connect the analog signal outputs of the
BioPAT
®
Xgas to the control tower of the
Biostat
®
C Plus as follows:
t Take the analog serial connection cable.
t Connect the cable plug labeled “Xgas” to
the right-hand socket of the BioPAT
®
Xgas.
t Connect the cable plug labeled “Ext.
Sig.-A” to the “Ext. Sig.1-2” socket of the
Biostat
®
C Plus.