9
§ Place the load plate on the scale
Connecting the Scale to AC Power
! Before putting the scale into operation, make
sure that the power cable is correctly connected
to the wall outlet (mains supply); it is especially
important to make sure the grounding cable is
attached to the housing of the YPS03-X.. AC
adapter (power supply). All devices used must
be connected to the equipotential bonding
conductor via the retainers provided on each
device. Installation must be carried out by
a certified electrician.
! Before putting the equipment into operation
for the first time, make sure that the area
of installation is not hazardous. If safety of
operation is not warranted (for example, as a
result of damage to the scale, during transport or
otherwise), disconnect the equipment from power
and contact a Sartorius service technician.
! Use only original Sartorius AC adapters
or power supplies:
– YPS03-X.. (for use within a hazardous
area/location)
– 609308-..1 (for use outside a hazardous
area/location)
§ Check the voltage rating and the plug design
– If they do not match the rating or standard you
use, contact your Sartorius office or dealer
To Next Page
Loading...
