28 Operating Instructions arium
®
mini plus | arium
®
mini | arium
®
mini essential
Installation
5.2 Prerequisites for Installation at the Installation Location
Procedure
t Make sure that the following conditions are met at the place of installation:
Requirement Features
Ambient conditions − Suitability tested (ambient conditions, see Chapter 14.2, page 73; electromagnetic
compatibility, see Chapter 14.4, page 74)
Footprint − Stable and level surface
− Sufficient space for the device (device space requirements, see Chapter “14.7
Device Properties,” page 76)
− Sufficient load capacity for the device, including when it has been filled
(device weight, see Chapter “14.7 Device Properties,” page 76)
Access to utilities − Access to utilities is a maximum of 2 meters:
− Feed water supply
− Power outlet
− Pressureless drain
Feed water quality − Suitability tested (see Chapter “14.6 Feed Water Quality,” page 75)
5.3 Unpacking and Setting up the Device
We recommend having the installation and initial startup of the device carried out
by Sartorius Service. Please contact Sartorius Service in this regard.
CAUTION
Risk of electric shock due to leaking water!
Water may spill when using the device. Electric shocks can occur if water comes into
contact with electrical appliances.
t Do not place the device close to electrically powered devices.
CAUTION
Danger of fire or explosion!
The device contains components that can ignite highly inflammable or combustible
materials.
t Do not operate the device in the vicinity of such substances.
Procedure
t If the device is stored: Observe the information on storage (see Chapter “10.1
Storage,” page 70).
t NOTICE Equipment damage due to improper transport! If the device is lifted
where there are loose components, it may fall and be seriously damaged.
t Never lift the device by the two side covers for transport.
t Grip the front of the device under the display and the recess for the power
supply at the back of the device and lift carefully.
To Next Page
Loading...