Sartorius H2O-MA-UV-T - Rinsing Pretreatment Cartridge

40 Operating Instructions arium
®
mini plus | arium
®
mini | arium
®
mini essential
Startup
6.7 Rinsing Pretreatment Cartridge (only arium
®
mini plus)
Procedure
t Open the ball cock on the tank outlet tubing.
t Run the tank outlet tubing to the drain for rinsing. Water can escape from the
tubing during rinsing.
t Start the rinsing process for the pretreatment cartridge.
To do this, tap the [START] button.
y During the rinse cycle, the remaining rinse time is displayed in minutes.
t To interrupt the rinse cycle:
t Tap the [x] button.
y The dialog box “Start rinsing” appears again.
t To resume the rinse cycle after an interruption: Tap the [START] button.
t When the rinse cycle is finished: Close the ball cock on the tank outlet tubing.
t Confirm that the tank outlet is closed. To do this, tap the [OK] button.
1
Prepare rinsing
Open the tank outlet (Bag Outlet) at the
rear of the device.
OK
1
Start rinsing
Tap “Start” to begin the rinsing process.
w
m
Rinsing
10:00 min
1
Close bag outlet
Close the tank outlet (Bag Outlet) at the
rear of the device.
OK