Sartorius H2O-MA-UV-T - Completing the Rinsing Process

Operating Instructions arium
®
mini plus | arium
®
mini | arium
®
mini essential 43
Startup
t Start the rinse cycle for the ultrapure water cartridge. To do this, tap the [START]
button.
y During the rinse cycle, the remaining rinse time is displayed in minutes.
t To interrupt the rinse cycle:
t Tap the [x] button.
y The dialog box “Start rinsing” appears again.
t To resume the rinse cycle after an interruption: Tap the [START] button.
y The rinse cycle is performed.
6.8.4 Completing the Rinsing Process
Procedure
y When rinsing is complete, the dialog box “End rinsing” appears.
t Remove the dispense tube. To do this, use the tubing removal tool to push the
dark ring of the quick connector up and pull the dispense tube down and out.
t Confirm the rinsing process with the [OK] button.
y The dialog box “Connect filter” appears. A final filter must be connected
(see Chapter 6.9, page 44).
1
Start rinsing
Tap “Start” to begin the rinsing process.
w
m
Rinsing
4:00 min
1
End rinsing
Remove the dispense tube.
OK
1
Connect lter
Connect the nal lter as described in
the manual.
OK