Sartorius H2O-MA-UV-T - Activating or Deactivating Standby Mode; Automatic ECO Mode

50 Operating Instructions arium
®
mini plus | arium
®
mini | arium
®
mini essential
Operation
y The dialog box “Fill bag” (Step 1) appears.
t Check whether the tank filling tubing is connected to the “Inlet” connection.
t If required: Connect the tank filling tubing.
t NOTICE Insufficient water quality possible due to contaminated tank filling
tubing! Check the tank filling tubing for contamination.
t If required: Change tank filling tubing and bag.
t Tap the [OK] button.
y The dialog box “Fill bag” (Step 2) appears.
t NOTICE Device functions can be impaired by air intake! If there is insufficient
water during the filling process: Air is drawn into the system. The air in the
system can impair correct functioning of the device. Prepare a vessel with
pretreated water (at least 5 liters).
t Place the tank filling tubing into the container and secure it so that its opening
is completely submerged during filling.
t Tap the [START] button.
y The bag is filled with water. Progress is displayed as a percentage.
t NOTICE Device functions can be impaired by air intake! If there is insufficient
water during the filling process: Air is drawn into the system. The air in the
system can impair correct functioning of the device.
t If there is insufficient water in the container: Cancel the filling process
prematurely and fill the container with pretreated water.
t To cancel the filling process prematurely:
t Tap the [x] button.
y The dialog box “Fill bag” (Step 2) appears.
t Carry out filling as described above again.
y When filling is complete, the dialog box “Filling finished” appears.
t Check that the free end of the tank filling tubing is secured.
t If required: Remove the tank filling tubing from the “Inlet” connection
at the rear of the device and keep it in a safe place.
t Confirm the bag filling process with the [OK] button.
y The display changes to the dispensing screen.
7.5 Activating or Deactivating Standby Mode
If no water is dispensed for a long time, the device automatically switches to
standby mode. This ensures more economical and ecological operation. In standby
mode, the pre-stage is no longer active and ultrapure water is no longer in
circulation. Standby mode can also be activated manually.
If the device is manually switched into standby mode while the bag is being
automatically filled, a prompt for further action appears. The filling of the bag can
be canceled immediately, which puts the device in standby mode. If filling is
continued, the device will automatically switch to standby mode.
7.5.1 Automatic ECO Mode
In addition to standby mode, the device also features an ECO function. One minute
after the last operation, recirculation of ultrapure water is stopped and the display
darkens. After another 15 minutes without touching the display, the device
automatically switches to standby mode.
1
m
Preparing to ll the
bag
Connect the tank lling tube (Inlet) to
the rear of the device as described in
manual.
OK
1
m
Fill bag
Make sure there is sufcient water to
ll the bag. Tap “START” to begin lling
the bag.
w
m
Fill bag
20 %
1
Filling nished
Remove the tank lling tube (Inlet) on the
rear of the device.
OK