Sartorius H2O-MA-UV-T - Cleaning and Maintenance; Cleaning the Display; Cleaning the Device Housing

Operating Instructions arium
®
mini plus | arium
®
mini | arium
®
mini essential 53
Cleaning and Maintenance
8 Cleaning and Maintenance
8.1 Cleaning
8.1.1 Cleaning the Display
Procedure
t To avoid uncontrolled changes to the settings of the device:
Activate standby mode (see Chapter 7.5, page 50).
t Wipe the display gently with a soft, dry cloth.
t Deactivate standby mode (see Chapter 7.5, page 50).
8.1.2 Cleaning the Device Housing
CAUTION
Danger of injury caused by electric current!
When cleaning the device and its components while they are connected
to the power supply, there is a risk of electric shock.
t Always disconnect the device from the AC power before cleaning.
NOTICE
The electronic equipment could be damaged by improper cleaning!
Liquids or dust can damage the device or the power supply.
t Never open the power supply or the right side of the device housing.
t Make sure that no liquids or dust get into the device or the AC adapter.
NOTICE
Damage to the device surfaces!
Aggressive cleaning agents may damage device surfaces.
t Never use cleaning agents that contain solvents, acetone or abrasive ingredients.
Procedure
t Disconnect the device from the power supply.
t Wipe the housing of the device with a damp cloth.
t If installed components must be cleaned: Remove the front cover and the left
side cover and wipe down the installed components with a damp cloth.
t Dry the device with a soft cloth.