Max 210 g
Mi n 1 g
e= 0.1mg
d=0.01mg
J
F H
S
There are 3 options for data output:
– Output to the display and control unit
– Output to a printer (generate a printout)
– Output to a peripheral device (e.g., computer) via the interface port
Output to the Display and Control Unit
The display is divided into 9 sections. Information about the balance,
the application being used and the sample weighed is output in the
following sections:
– Line for metrological data
– Bar graph
– Plus/minus sign, stability symbol display
– Line for measured values (weights)
– Weight unit display
– Data in tare memory; calculated value
– Application symbol display
– Text line
– Soft key labels
Line for Metrological Data (on balances verified for legal metrology)
This line shows:
– Maximum weighing capacity (such as 210 g)
– Minimum weighing capacity; the weight must not go below this limit
in Germany (such as 1 g)
– Verification scale interval; irrelevant if the balance is not used in legal metrology
(such as 0.1 mg)
– Readability/actual scale interval: indicates the balance’s display increment in digits
(such as 0.01 mg)
Bar Graph (overview display)
In the bar graph, weighing results are displayed either
– as a percentage of the maximum balance capacity, or
– in relation to a target value, with tolerance limits indicated.
You can turn off (blank) the bar graph display (Setup: Device parameters:
Display: Digit size: 13 mm + text display or 13 mm)
Plus/Minus Sign, Stability Symbol
This section shows:
– “Busy” symbol
– Plus or minus sign
– Zero symbol (indicating the scale has been zeroed)
To Next Page
Loading...
