Setup and Configuration PR 5210 Operating Manual
20 Sartorius
4.3 Load and store setup and configuration
4.3.1 Data in the PR5210
The current data can be loaded from the PR5210 to the configurations-tool, edited and save back to
the PR5210.
In the menu 'ADU' and 'Parameter' the data sets
can be loaded and stored.
Each time all data are loaded or stored.
If the data are changed, the program asks when a page is changed or the program will be quit, if the
changes should be stored or abouted.
If an access code is set, it will be asked now.
4.3.2 Archive data in the PC
The actual data set in the configuration tool could be stored as a file on the PC and reloaded again. So,
all configuration data could be archived on the PC.
Load Dataset
Load the default values (factory delivery) contained in the file DEFAULT.DAT for
the WIN tool. The default dataset cannot be overwritten. If a new configuration
has to be stored, change the name.
Save Dataset
Store the modified data under a name different from DEFAULT.DAT
4.4 Print data set
Print Dataset
The current calibration data and all parameters are printed on the printer
assigned as standard printer. See example in chapter 8.4.
To Next Page
Loading...
