Sartorius Sartocheck 3 plus - Service Operations (Continued); Software Configuration Settings

39
7.16.2 Software Configuration (F3-Service)
With the software configuration you can define:
Language German
English
French
Spanish
Italian
Date format dd.mm.yyyy
dd/mm/yyyy
dd-mm-yyyy
mm/dd/yyyy
yyyy/mm/dd
yyyy.mm.dd
Date as defined above
Time hh.mm.ss
Reference 1000 mbar (abs)
pressure 1013.25 mbar (abs)
– Unit of measure
Pressure mbar
psi
hPa
WIT unit ml/10min
ml/min
Temperature °C
°F
K
All units of measure can be reset to Sartorius Stedim Biotech values using F1.
Pressure: mbar
WIT unit: ml/10min
Temperature: °C
– Test log data
For each type of test (Diffusion, Bubble Point, etc) you can define your basic record
data. These defined parameters will then apply to all test programs. Go from the
Service Menu – Software Configuration – Record data to the overview screen of
the test type. Now select the desired test type, e.g. Diffusion or Bubble Point Test.
You are immediately taken to the list of the record fields.
Starting with company, building, department you can now define individual record
fields by placing a checkmark or canceling in the “Selection” field.
The selected fields are printed out by the internal printer of the Sartocheck® 3 plus.
Individual fields can be activated or deactivated by pressing the respective function
key.
Fig. 7-54 | Service Menu:
Software configuration
Fig. 7-55 | Service Menu:
Software configuration
Fig. 7-57 | Service Menu:
Software configuration
Fig. 7-56 | Service Menu:
Software configuration