The information given in these operating instructions applies to Sartocheck
®
4 plus
Filter tester, Order no. 26288---FT and Sartocheck
®
4 Filter tester MultiUnit,
Order no. 26288---FM.
The manufacturer’s label is affixed to the rear panel of the unit.
Important: if you have any questions
Always have the following information ready:
– Model
– Version
– Serial number
Having the right information readily available will ensure correct and quick
processing.
3.2 Installed Safety Equipment The installed safety equipment must be inspected at regular test intervals
(d = daily, w = weekly, m = monthly). The test methods used are: S = sight inspection,
F = functional testing.
The unit has the following safety equipment installed:
Line Disconnector
The unit is disconnected from the mains voltage by switching off the unit or when
the unit is unplugged from the wall outlet (mains supply).
Housing
All unit-specific components are shielded against external influences by a plastic
housing. It is strictly forbidden to disengage or dismantle the safety equipment.
The function of this safety equipment must be inspected and tested according to the
instructions given in the Chapter “Maintenance”.
The operator is responsible for instructing the operating personnel and
service and maintenance personnel about the meaning and the function
of the safety equipment.
These operating instructions are an integral part of the unit and must be available to
operating personnel and service and maintenance personnel at all times.
The safety precautions and warnings contained herein must be observed.
3.3 Safety Precautions The operator must
(to be carried out by – instruct their operating and servicing personnel in the use of the filter cartridge
the operator) housing’s safety devices and
– ensure that the safety precautions are complied with.
– prevent unauthorized persons (not operating and servicing personnel) from
accessing the filter cartridge housing danger zone.
These operating instructions must be kept in a safe place for future reference.
The frequency of inspections and checks must be observed.
The work described in these operating instructions is explained in such a way that it
can be understood by trained workers and qualified technicians.
Safety 11
Test
Interval Method
m S/F
Test
Interval Method
m S
To Next Page
Loading...
