86
USB Port
User Manual Secura
®
, Quintix
®
, Practum
®
10.3 Interface Specification
10.3.1 Data Output
You can define the data output parameter so that output is activated either when a
manual print command is received or automatically synchronized with the display or
at defined intervals (see application programs and autoprint settings).
Data Output following Print Command The print command can be transmitted by pressing the
a key or by software
command (Esc P).
Automatic Data Output In
Autoprint mode, data is output to the data interface port without an extra print
command. You can have synchronized data output automatically or at defined
intervals, with or without balance stability.
If the automatic data output is activated in the Device Configuration, it starts
immediately after the balance is turned on.
10.3.2 Data Output Formats
You can output the values with or without an identifier. The output format is
configured in the device settings (see page 34).
Example: Output without ID + 253 pcs (16 characters are printed, “SBI” mode only)
Example: Output with ID Qnt + 253 pcs (22 characters are printed, always with ID for printers
and “PC text format”)
Data Output Format with 16 Characters
Characters that are blank on the display are printed as spaces.
Display values without a decimal point are printed without a decimal point.
Normal Operation
Position 12345678910111213141516
+AAAAAAAAA* EEECRLF
or --........ ***
or **********
* Space CR Carriage return
A Displayed characters LF Line feed
E Unit of measure characters . Decimal point or comma
To Next Page
Loading...
