Connecting Electronic Devices (Peripherals)
! Make absolutely sure that the balance is unplugged from the power supply before
connecting/disconnecting a peripheral device (printer or PC) to or from the
interface port.
Warm-up Time
To return precise results, the balance must warm up for at least 30 minutes after
initial connection to the power supply.
Only after this time will the balance have reached the required operating
temperature.
Using a verified balance in legal metrology:
y Make sure to allow the device to warm up for at least 24 hours after initial
connection to the power supply.
8 YPS02-X.. Installation Instructions
Installation
To Next Page
Loading...