5. Select filter replacement run time
The thermostat will display the Filter Alarm after a set time of operation. This
is a reminder to change or clean your air filter. This time can be set from 0 to
12 months in 1 month increments. Selection of 00 WILL CANCEL THIS
FEATURE.
6. Select ºF or ºC readout
Changes the display readout to Centigrade or Fahrenheit as required.
7. Select temperature recalibration
This feature allows you to adjust the displayed room temperature up to 4º
higher or lower. Your thermostat can be accurately calibrated to match your
previous thermostat. The current or adjusted room temperature will be
displayed on the display.
To Next Page
Loading...
