Satec PM130 PLUS Series - Configuring the Display

Chapter 5 Configuring the PM130 PLUS General Meter Setup
PM130 PLUS Powermeter Series_Installation Operation and Manual 102
5.2.8 Configuring the Display
This setup allows configuring the meter display. It also has an entry for launching the meter Flash Loader.
Using the Front Display
Select the diSP entry from the main menu. See Viewing and Changing Setup Options in Chapter 3 for
information on configuring parameters via the front display.
See Table 27 for the available options.
Table 27: Display Setup Options
Display
Label
Parameter
Options
Default
Description
UPdt
Display update rate
0.1-10.0 sec
1 sec
Defines the interval between display updates
ScrL
Auto scroll interval
None,
2-15 sec
None
Defines the scroll interval for the main data
display or disables auto scroll
rEtn
Auto return to the
main screen
diS = disabled,
En = Enabled
Enabled
Enables automatic return to the main display if no
buttons are pressed for 5 minutes
bAr
Reference load
current for LED bar
graph
0-10,000A
(0 = CT primary
current)
0
Defines the nominal load (100%) level for the bar
graph display
Uolt
Primary/Secondary
volts units
Pri = primary
SEc = secondary
Primary
Selects primary or secondary units for volts
display
Ph.P
Phase powers
display mode
diS, En
Disabled
Disables or enables phase powers in the main
display
Fund.
Fundamental
component display
mode
diS, En
Disabled
Disables or enables fundamental values in the
main display
dAtE
Date order
dnY, ndY, Ynd
(d=day, n=month,
y=year)
mm.dd.yy
Defines the date order in the RTC display
rSt
Simple reset mode
PASS = password
protected
En = always
enabled
PASS
PASS = the simple reset is not allowed if
password protection is enabled
En = enables the simple reset buttons regardless
of password protection
brGt
Brightness
1-3
3
Sets the LED brightness
diAG
Diagnostic LED
diS, En
Disabled
Enables the diagnostic LED
FLSH
Flash Loader call
N/A
N/A
Launches the Flash Loader