Satec PM130 PLUS Series - Configuring the Daily Tariff Schedule

Chapter 5 Configuring the PM130 PLUS Configuring Billing/TOU
PM130 PLUS Powermeter Series_Installation Operation and Manual 108
Parameter
Options
Default
Description
Register Source List
Source
Input
None
kWh Import
kWh Export
kvarh Import
kvarh Export
kVAh,
DI1-DI4
None
Links an energy source to the register
Multiplier
0.001 to 100.000
1.000
The multiplication factor for the energy source. Unchangeable for
internal energy sources.
Target
Reg#1- Reg#4
None
Defines the target billing register for the energy source. It is set
automatically.
5.4.2 Configuring the Daily Tariff Schedule
To configure your daily tariff schedule, select Energy/TOU from the Meter Setup menu, and then click on
the TOU Daily Profiles tab.
Figure 5-16: Energy/TOU Setup Dialog Box – TOU Daily Profiles Tab
The daily profile setup allows you to specify the daily tariff change points with a 15-minute resolution for 4
seasons using 4 different daily schedules for each season.
To configure your daily profiles:
1. Select the desired season and day type.
2. Select the start time for each tariff change point and the corresponding active tariff number.
3. Repeat the setup for all active profiles.
The first tariff change point is fixed at 00:00 hours, and the last tariff change you specified will be in use
until 00:00 hours on the next day.
NOTE
The billing daily profile log file is automatically configured for the number of active tariffs you defined in the
meter TOU daily profiles.